Keyless2Go Un-Cure CA Debonder

Size: 1oz

Thisdebonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of Debonder will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option.

Uses:

• Cyanoacrylates
• Super Glues

How To Use:

Un-Cure will soften cured super glue (aka cyanoacrylate, CA). To release bonded skin (not near the eyes) apply debonder, then use a small, rounded object like a paperclip to separate the skin with a peeling action, applying moredebonder as needed until the skin areas are debonded. Wash the area with soap and water. The natural shedding of the skins outer layer will remove any residual CA within 12 hr. For removing CA from hard surfaces, soak a cloth or paper towel in debonder and rub areas vigorously. Debonder, however, will mar most plastics.