Mitsubishi MIT3 Transponder Key, G Type: 46 – Aftermarket

In stock

Product DetailsChip Type: Philips ID 46 Honda GStamp on Blade: NoKeyway: MIT3Included ComponentsTransponder key onlyProgram key with your programmer of choice or OBP if you have 2 working keys!On-Board Programming Instructions:To add a key, you must alread

$30.99 $24.79

Share :

Product Details

  • Chip Type: Philips ID 46 Honda G
  • Stamp on Blade: No
  • Keyway: MIT3
  • Included Components

  • Transponder key only
  • Program key with your programmer of choice or OBP if you have 2 working keys!
  • On-Board Programming Instructions:
  • To add a key, you must already have two programmed keys. You can have a total of 8 keys programmed.
  • 1. Insert the first original key into the ignition switch and turn the key to the ON position for 5 seconds.
  • 2. Turn the key to the OFF position and remove the first key.
  • 3. Within 30 seconds of removing the first key, insert the second original key into the ignition and turn it to the ON position. Approximately 10 seconds later, the immobilizer light will start to blink.
  • 4. When the immobilizer light starts blinking, turn the second originalkey to the OFF position and remove it. Within 30 seconds, insert a blank immobilizer key into the ignition switch and turn it to the ON position. Perform this operation no more than 30 seconds after the immobilizer display starts blinking. When programming is complete, the immobilizer display will come on for 30 seconds then go off. If an error occurs, the blinking immobilizer display will go off during the procedure.
  • 5. If you wish to program an additional key, perform these steps again starting from step one.
  • Reviews

    There are no reviews yet.

    Be the first to review “Mitsubishi MIT3 Transponder Key, G Type: 46 – Aftermarket”

    Your email address will not be published. Required fields are marked *

    Related products